Rings
- Cut a thin strip of paper approx. 1/4 inch or 7mm wide
- Wrap the paper around your finger. Make sure the paper is below the joint of your finger and close to your knuckle.
- Mark the spot where the paper meets and measure the distance with your ruler.
- Use the following chart to determine your ring size.
- If you are between sizes, choose the bigger size.
All of our rings are ordered in US sizing.
To convert internationsal sizing, use chart below
The picture below is only an approximation. Bigger men and men who work out a lot will probably need a larger size of chain. To find exactly the size that's right for you, or to test the length of a one-of-a-kind necklace, follow these directions
(A) To choose a length:
Put a piece of string around your neck. When you find the desired length,hold the string together as you remove it. And mark the overlap with a pen (felt-tip works best)
Open the necklace and measure against an inch ruler or tape measure.. (All of our necklaces are in inches)
To test an offered length:
(B) To test an offered length:
* Cut a piece of string approx. 1 inch longer than the necklace. Mark the finished length.
* Put the string around your neck, overlaping to the mark to see the length around your neck.
Follow the (A) instructions for the necklaces to choose a length, making sure that you have enough slack that the bracelet can move freely around your wrist.
Using the same technique with the string. Measure directly around wrist for a snug fit.